|
|
Post by copperhead2959 on Feb 4, 2013 18:02:49 GMT -6
I am trying to replace the ignition switch on a 95 yamaha seca 2 but i dont know how to get it off the triple tree clamp. the bolts holding it on dont have heads and im not sure how to go about this, help would be greatly appreciated guys. here are some pictures Attachments:
|
|
|
|
Post by copperhead2959 on Feb 4, 2013 18:05:23 GMT -6
this is one of the backside, sorry for the horrible pictures but its all i've got  Attachments:
|
|
|
|
Post by Doc on Feb 5, 2013 0:49:15 GMT -6
|
|
|
|
Post by copperhead2959 on Feb 5, 2013 8:55:05 GMT -6
that is the right switch and the diagram is correct except there are two bolts not one on mine and the are not hex heads. they are smooth i cut a slot in them with a dremel but they wont budge
|
|
|
|
Post by brad on Feb 5, 2013 10:46:42 GMT -6
These are shear head bolts, and a witch to remove. Spray liberally with WD-40, or your choice of product, let soak, and either get aggressive with your dremel slot cutting, or use a chisel. I've also gotten these out by drilling down the center and using a screw extractor.
|
|
|
|
Post by copperhead2959 on Feb 5, 2013 16:59:21 GMT -6
i broke a bit in an attempt to use an impact driver to remove them and they still wont budge these things are insane.
|
|
|
|
Post by copperhead2959 on Feb 5, 2013 18:32:54 GMT -6
welp I cheated guys. took it to a shop a minute ago, the little beasties should be freed tomorrow.
|
|
|
|
Post by copperhead2959 on Feb 7, 2013 16:47:09 GMT -6
in all 5 bits were broken and that includes an easy out but its all good now, they got it apart
|
|
